SUBSIM: The Web's #1 resource for all submarine & naval simulations since 1997 |
03-26-09, 04:59 AM | #14 |
Stowaway
Posts: n/a
Downloads:
Uploads:
|
First of all I do experience lots of hungapps (Not responding) status when operating this program.
Usually it crashed on me when hiting serial port button. Then when I finally managed to brake through hungups this is what I saw: It's not like there (Com 1 should read N N N N Y Y on the signals) and after I put the dot on com1 and hit OK it hungups again I did disconnected the UPS end of the cable, completely switched off pc. Turned it on back again. And there were still lots of hungapps. When I disconnected the RS 232 cable from pc restarted and ran the digicom.exe again signals changed to N N N N Y Y on com1, but hangups still occur Last edited by Contact; 03-26-09 at 05:18 AM. |
|
|