SUBSIM Radio Room Forums - View Single Post - sh3.exe

Padi Muffdiver · 09-20-14, 05:25 PM

New member here. After floating adrift for a day in my technical problem I'm shooting off a flare to seek some help.

PROBLEM: after 40+ campaign missions into Feb. 1944 (so close to the type XXI) my SH3 Commander and direct launch both tell me "sh3.exe - Entry Point Not Found. The procedure entry point Direct3DCreate9Ex could not be located in d3d9.dll".

Originally I did a clean install of SH3 minus Starforce and patched to 1.4b. I then installed Living Silent Hunter III with the 4GB patch and a JSGME load of LSH3_V5, LSH3_V5.1, and DX9HiResFix. I run it through SH3 Commander on a WIN7/64bit high end PC.

I'm hoping the experts here can throw me a life preserver. Otherwise I may try saving my career info, doing a full uninstall, then re-installing everything.

Thank you (treading water) !

09-20-14, 05:25 PM	#1
Padi Muffdiver Watch Join Date: Sep 2014 Location: Indiana and Arizona Posts: 22 Downloads: 52 Uploads: 0	sh3.exe - Enry Point Not Found New member here. After floating adrift for a day in my technical problem I'm shooting off a flare to seek some help. PROBLEM: after 40+ campaign missions into Feb. 1944 (so close to the type XXI) my SH3 Commander and direct launch both tell me "sh3.exe - Entry Point Not Found. The procedure entry point Direct3DCreate9Ex could not be located in d3d9.dll". Originally I did a clean install of SH3 minus Starforce and patched to 1.4b. I then installed Living Silent Hunter III with the 4GB patch and a JSGME load of LSH3_V5, LSH3_V5.1, and DX9HiResFix. I run it through SH3 Commander on a WIN7/64bit high end PC. I'm hoping the experts here can throw me a life preserver. Otherwise I may try saving my career info, doing a full uninstall, then re-installing everything. Thank you (treading water) !