SUBSIM Radio Room Forums - View Single Post

05-09-06, 09:05 PM

I'm having the same problem. If I have a target out at 9000 yards, it doesn't seem to matter when I set the torpedo to go active (I've tried everything from 7000 to 1000), it doesn't seem to go into active mode. Before I installed SCXII or even SCXIIc I used to get a little red line in front of the Torp showing when it went active (and an annoying wagging which Is why I installed SCX) and where it was scanning, but not anymore. No matter when I tell it to go active it just keeps going straight. BTW, I'm using the Mk48.

I mean I can get the Torp pretty dang close to that oil tanker too, but it just wont do it.

I'm trying to finish the last training mission, in case that's a factor.

05-09-06, 09:05 PM	#1
Aladar Stowaway Posts: n/a Downloads: Uploads:	I'm having the same problem. If I have a target out at 9000 yards, it doesn't seem to matter when I set the torpedo to go active (I've tried everything from 7000 to 1000), it doesn't seem to go into active mode. Before I installed SCXII or even SCXIIc I used to get a little red line in front of the Torp showing when it went active (and an annoying wagging which Is why I installed SCX) and where it was scanning, but not anymore. No matter when I tell it to go active it just keeps going straight. BTW, I'm using the Mk48. I mean I can get the Torp pretty dang close to that oil tanker too, but it just wont do it. I'm trying to finish the last training mission, in case that's a factor.