Heads up, new version. See first post.
If you want to see the problem i fixed, enter these values with version 1.0:
B1: 10 degrees
B2: 15 degrees
B3: 23 degrees
Now repeatedly hit send on B3 LOL.
whoops.
Why did this happen? Because in the beta version you could not change data once entered. You had to hit reset button.. which is where the display scaling resets itself (the internal lines are scaled so they fit the bearing wheel nicely). Anyway I forgot to add a call to have it reset the scale whenever you change any of the bearings. This actually has another effect of the "show solution" lines being drawn in the wrong spots sometimes after a few changes.... despite the solution readouts being correct.
Last edited by gutted; 04-05-10 at 08:46 PM.
|