Quote:
Originally Posted by Abd_von_Mumit
Pointer D shows your view optics bearing (so you can only move this pointer when in scope/UZO - no way to change it when in map view and using Attack Disc). To move it, set your optics to desired bearing, then click the Attack Disc Lock Toggle Button (in the middle of the Disc) twice - your D ring will be set to proper bearing.
EDIT: As TDW explained in his post above mine, moving C-ring will also move the D-ring - so after any changes in rings setting it's wise to click the Toggle button twice again, so that D-ring is put in its right position before taking measurements.
|
you should be able to change pointer D using the bearing TDC dial. Is this not true in the nav map? Or did I remove the bearing TDC dial from the nav map? If so, I'll need to restore that dial.