Quote:
Originally Posted by Capt Jack Harkness
Nice, should look awesome when it's done!  |
After playing around with the Hull Textures, trying to get the glue seams in place decide not to do it. The Uboat7_Body.dds is very small when compaired to the area that it is tiled to on the hull and ends up looking like a mess.
I did get the glue seams on the Tower but after I completed, I realised I had done it @ 2048 x 2048 x 192 dpi. This made all the glue seams half the thickness when rendered and the detail doesn't show until you get close. I may go back and redo all these seams @ 1024 x 1024 x 96 dpi to increase visual effect.
I did finish the Deck and it looks good but wanted to add glue and sealer effect along the entire outter edge to simulate the rubber mats being glued on to the hull. I think I am just going to skip this because it would take way to long and the way the texture is mapped to the deck, it may cause problems.
