[Jeff-Groves]

I get what was done.
All 3 sectors were not adjusted and tested properly.

Now I'm working on a way to have 010 check the 6 pixel boarder areas around any given RAW file/files.

So the script would read the 1st 6 lines of 601 bytes each.
Then read the next 6 bytes then skip to the last 6 bytes of the lines until we reach the last 6 lines which would read them start to end.
That would give us the border information for a RAW.

Run it on all sectors touching? You'd have a table that would not need slight color guessing.

I did check sectors in the area in question but I looked at the upper and lower sectors!
Not the left or right sectors.
Doh!


Another thing I'm working on is to change the UI of the program to allow a bigger image when using it.
Also trying to change it so that damned header information is removed when exporting from the ZHF files.