This first phase of the lining of the walls, is being more complicated than expected. There are many things that need to be done, like the electrical box, that needs to be left accessible if need be.
A sample of the work done with the electrical box.
Finished the first section, I start the second one.
Once finished, the second, I install the piece that will allow the Hull's rib to look like a IP section iron rib.
Adjusting the piece to the side. (Note the pencil mark with the inclination for the cut)
Installed and ready the first rib with the union plate bolted to to it.
To allow you to understand how I do to make it look an Iron IP rib, I upload this shot with a piece of provisional channeled wood board, with round edges, that will be the "wings" of the inverted T rib's cross section.
First and second sections done... ready for the third!
If I can, tomorrow more
.