SUBSIM Radio Room Forums - View Single Post - [REL] Rik007: SH-3 Night surface attack project [REL]

rik007 · 03-15-24, 03:12 PM

Hi Doolar,

1. was the Merchant Ship Mod (full) issue corrected witl the new version (1.19)

There was an issue with FPS performance. That one is solved as 1.19 has been optimized

.

The memory issue (CTD) with the full Merchant Ship Mod was unrelated to the night surface attacks mod as the CTD's also occured when only the full Merchant Ship Mod was enabled. The CTD's do not happen always so that makes it confusing.

2. (the dumb question) The installation instruction stated to run the patcher but it didn't state to copy the SH3.exe to that patcher folder. I would assume you do. is that correct.

Dumb questions do not exist for me and this is not even a dumb question at all

. The patcher will take the sh3.exe from your sh3 folder and store the patched sh3.exe into the 'SH-5 Moon mod' folder. So you only need to enable it afterwards with JSGME.

03-15-24, 03:12 PM	#87
rik007 Seasoned Skipper Join Date: Jan 2002 Location: Holland Posts: 720 Downloads: 117 Uploads: 0	Hi Doolar, 1. was the Merchant Ship Mod (full) issue corrected witl the new version (1.19) There was an issue with FPS performance. That one is solved as 1.19 has been optimized . The memory issue (CTD) with the full Merchant Ship Mod was unrelated to the night surface attacks mod as the CTD's also occured when only the full Merchant Ship Mod was enabled. The CTD's do not happen always so that makes it confusing. 2. (the dumb question) The installation instruction stated to run the patcher but it didn't state to copy the SH3.exe to that patcher folder. I would assume you do. is that correct. Dumb questions do not exist for me and this is not even a dumb question at all . The patcher will take the sh3.exe from your sh3 folder and store the patched sh3.exe into the 'SH-5 Moon mod' folder. So you only need to enable it afterwards with JSGME. Last edited by rik007; 03-15-24 at 03:40 PM.