Charging batteries in .26 Open Beta
Charging batteries in .26 Open Beta
"Half Speed" 340 RPM 1.8kA Charge- Get the Diesel up to a stable RPM of 340+60 to 70 -> 400-410 RPM
- Set Motor Direction OFF
- Set Motor Power ON
- Set Motor Parallel & Battery Series
- Set Speed Control Voltage to Low
- Set Motor Direction forward
- Adjust Speed Control Voltage so the RPM Matches 340 while not exceeding 800 Motor current.
- Verify Battery charge current is 1.8kA -> if not adjust the throttle and Speed Control Regulator to meet the ordered 340 RPM while charging at 1.8kA
"Slow Speed" 255 RPM 1.8kA Charge- Get the Diesel up to a stable RPM of 255+60 to 70 -> 315-325 RPM
- Set Motor Direction OFF
- Set Motor Power ON
- Set Motor Parallel & Battery Series
- Set Speed Control Voltage to Low
- Set Motor Direction forward
- Adjust Speed Control Voltage so the RPM Matches 255 while not exceeding 800 Motor current.
- Verify Battery charge current is 1.8kA -> if not adjust the throttle and Speed Control Regulator to meet the ordered 255 RPM while charging at 1.8kA
"Dead Slow" 255 RPM 1.4kA Charge- Get the Diesel up to a stable RPM of 180+60 to 70 -> 240-250 RPM
- Set Motor Direction OFF
- Set Motor Power ON
- Set Motor Parallel & Battery Parallel
- Set Speed Control Voltage to Low
- Set Motor Direction forward
- Adjust Speed Control Voltage so the RPM Matches 180 while not exceeding 800 Motor current.
- Verify Battery charge current is 1.4kA -> if not adjust the throttle and Speed Control Regulator to meet the ordered 180 RPM while charging at 1.4kA
While stopped 1.8kA Charge- Get the Diesel to idle at minimum throttle
- Decuple screw
- Set Motor Direction OFF
- Set Motor Power ON
- Set Motor Parallel & Battery Series
- Set Speed Control Voltage to Low
- Set Motor Direction forward
- Raise the throttle to maintain high cylinder temp for later use while not exceeding 800 Motor current.
Last edited by Flubbo; 12-30-23 at 05:01 PM.
|